Hemming Dies

Description:

• H-1 Hemming Die Set

Is a low cost hemming die set that forms a teardrop or an open hem in a single handling without die change or adjustment. The greatest length of fold-over is 2 inches. In the closing operation, the material must be tilted and held high enough in the die to enable the punch point to pass the bend edge formed previously. A slight bow in the length of the sheet can be anticipated.

• Used for 18-gauge and lighter material.

• H-2 Hemming Die Set

Is a low cost hemming die set that forms a teardrop or an open hem in a single handling without die change or adjustment. In the closing operation, the material must be tilted and held high enough in the die to enable the punch point to pass the bend edge formed previously. A slight bow in the length of the sheet can be anticipated.

• Used for 16-gauge and heavier material.

• H-4 Hemming Die Set

The H-4 hemming die set to bend the acute angle in the upper level and to close the hem in the lower level.

• Used for 18-gauge and lighter material.

• Closing operation is adjustable for forming open or closed hems.

• H-5 Hemming Die Set

The H-5 hemming die set to bend the acute angle in the upper level and to close the hem in the lower level.

• Used for 14-gauge and heavier material.

• H-6 Hemming Die Set

Is a combination set that eliminates whip-up of the material. This curbs operator fatigue which is an important safety factor.

• Used for 18-gauge and lighter material.

• H-7 Hemming Die Set

The H-7 die set allows for a standard acute die set to be used as shown for hemming; In addition the middle section can be locked in the closed position emulating a standard die holder.

• Closing operation is adjustable for forming open or closed hems.
• The middle section can be locked in the closed position and used as a standard die holder.